2013 Chevrolet Suburban
Mileage
206,866
Service Date
10/19/2020
Services Performed
- AXLE SHAFT ASSEMBLY – Remove & Install or Remove & Replace – K1500 One Side – [Includes: R&I Shock Assembly.] – [NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists of Axle Shaft, Boots and Joints.]
- BALL JOINT – Remove & Replace – K1500,4WD Lower,One Side – [DOES NOT include alignment.]
- BALL JOINT – Remove & Replace – K1500,4WD Upper,Both – [Serviced with Control Arm.] – [DOES NOT include alignment.]
- CHECK ENGINE LIGHT IS ON.
- DIFFERENTIAL FLUID – Drain & Refill – All Applicable Models
- DRIVERS REAR SEAL IS LEAKING,
- LUBE OIL & FILTER
- PINION SHAFT SEAL – Remove & Replace – All Applicable Models
- SCAN TEST ELECTRICAL SYSTEM FOUND CODE P015B AND P015D HO2S DELAYED RESPONSE LEAN TO RICH BANKS 1 AND 2 SENSORS 1. MONITORED FUEL TRIM DATA TO FIND NO WITHIN SPECS. REMOVED MAF SENSOR TO FIND DIRTY. CLEANED MAF SENSOR AND RESET FUEL TRIMS TO FIND FUEL TRIMS WITHIN SPECS. CLEARED CODES AND TEST DROVE VEHICLE TO FIND NO FAULTS OR CONCERNS PRESENT AND VEHICLE OPERATING PROPERLY.
- SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – C1500,K1500 Both – [DOES NOT include disassemble or alignment (where applicable).]
- TRANSFER CASE FLUID – Drain & Refill – 4WD w/o Skid Plate
- TRANSMISSION SERVICE COMPLETE FLUSH
- WHEEL SEAL – Remove & Replace – C1500,K1500 Semi-Floating Axle,Both – [Includes: Repack and adjust Bearings (where applicable).]
- ALL WHEEL ALIGHN
COLETTE G. gave our service a 5 star review on 10/20/2020
